We build infrared heaters that shine where you need them most—in the dark. Seriously. They’re made for spots where you want serious heat, but can’t deal with a blinding glare. These aren’t your average lamps. They’re precision tools, designed for one thing: hitting a specific target on the factory floor with focused warmth. Here’s what that means for you on the ground. A typical unit runs at 400V and 2500W. That’s a lot of power packed into a short, 300mm tube. It gives you a heat source that’s intense, but small enough to slip into tight spaces inside your machines. And the 400V rating? It’s not random. It’s there so the heater can plug straight into standard industrial power. No extra transformers. No messy wiring. Just a clean, simple install. Now, let’s talk about what’s inside. The heart of it is a halogen-filled quartz tube. That chemistry is what keeps the filament stable, so the heater doesn’t burn out on you. It just keeps running, consistently, for thousands of hours. The tube is also coated to filter out the visible glare. So you get all the infrared heat you need, without the harsh light that can strain your eyes or mess with cameras and sensors. And the R7s connector? It’s a straight, two-ended fit. That means you can swap these right into your existing fixtures. No re-wiring. Just a simple replacement. So where does this all come together? These heaters are built to survive the grind of industrial cycles—think PET blowing, plastic pre-heating, the works. The low-light design keeps your operators comfortable and your sensors happy. But here’s the thing to remember: that 2500W output is serious. It means you need to make sure the machine has the right cooling and shielding in place. If you need a focused, controllable heat source with minimal visible light, this is the practical way to get it done.